0 item(s) - $0.00
You have no items in your shopping cart.

0

Bottom Coil Clearomizers : What are they ? How do I use one ? How to clean or change the heating coil?

Bottom Coil Clearomizers : What are they ? How do I use one ? How to clean or change the heating coil?

An increasingly popular alternative to the usual CE5 clearomizers are bottom coil clearomizers. These have the heating coil low down in the tank (at the bottom) and sit submerged in the e-liquid rather than relying on wicks to get the e-liquid to the heating element in the coil.

Kanger EVOD
The Kanger EVOD bottom coil clearomizer is available for %5.99 while the Kanger Protank 2 buttom coil clearomizer is available for $19.99.

The EVOD and Protank II use coils that will fit the other as well as the original Protank and Mini Protank I and II. This allows you to use one stock of coils for both clearomizers.

EVOD coils and Protank coils

To change the coil, turn the tank upside down and unscrew the base. Ideally using gloves if there is e-liquid in the tank, unscrew the coil from the base and discard. Screw a new coil into place and screw the base back into the tank.

To change flavours the inside of the tank should be washed out to avoid mixing flavours – unless you want to try a new flavour!

The EVOD and ProTank use a special high quality Clearomizer with a replaceable bottom fed coil. The coil is the atomizer piece with wicks. The wicks help to absorb liquid into the atomizer to be converted into a smooth vapor experience.

After some time of use, your atomizer coil may go out and need to be replaced. These high quality replacement coils will allow you to cheaply and easily extend the life of your EVOD or ProTank

Maintenance: The Bottom Coil Clearomizer uses replaceable heating elements that are screwed into the base, these coils are available to buy and will give new life to your device. A new coils will give a completely fresh vaping experience replacing the coils along with any built up deposits.

 

How to change the heating coil in your EVOD:

kanger evod how to change coil head

  • Unscrew the bottom assembly from the tube, unscrew the old atomizer coil and replace with a new coil by screwing it back on the base.
  • If you need to refill your EVOD, fill with 1.6mL e-Liquid by tilting the EVOD at a slight angle and dripping juice down the inside wall against the outer wall of EVOD. Do not put eliquid into the center tube as it will leak out the bottom of EVOD.
  • Insert the base/coil into the center tube and screw the base back onto the EVOD.
  • Screw the EVOD back onto your battery and you're ready to vape.

 

How to fill EVOD Bottom Feeding Clearomizer:

how to fill kanger evod buttom coil clearomizer

Filling is done differently, with most bottom coil clearomizers being filled by inverting the clearomizer and then unscrewing the base, leaving the upside down tank with drip tip attached. This tank is filled before the base is screwed back on ready for use.

  • Unscrew the bottom assembly or base from the tube.
  • Hold the EVOD tube upside down with the drip tip facing down
  • Fill with 1.6ml e-Liquid by tilting the EVOD at a slight angle and dripping juice down the inside wall against the outer wall of EVOD. Do not put eliquid into the center tube as it will leak out the bottom of EVOD.
  • Insert the base/coil into the center tube and screw the base back onto the EVOD.
  • Screw the EVOD back onto your battery and you're ready to vape.
Leave a Reply

Sorry, you must be logged in to post a comment.